Table des Matières
Publicité
ENGLISH
TIPS FOR BEST RESULTS
•
Always hold the shaver at right angles to the skin so that all three heads are touching
the skin with equal pressure.
•
Use moderate to slow stroking movements. The use of short circular motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
•
DO NOT press hard against the skin in order to avoid skin irritation.
CARE FOR YOUR SHAVER
Care for your appliance to ensure a long lasting performance. We recommend you clean
your appliance after each use.
•
Ensure the appliance is switched off and unplugged from the mains before cleaning.
1.
Open the shaver head by pressing the release button (Fig. C).
2.
The head assembly will open (Fig. D).
3.
Rinse under a tap to wash away hair trimmings.
4.
Carefully brush away any hairs from the cutters.
5.
Close the head assembly.
Note: The individual cutters are designed to be permanently retained in the shave head and
flushed out with water. Do not remove the individual cutters for cleaning.
DETAIL TRIMMER
Lubricate the teeth of the detail trimmer every six months with a drop of sewing machine
oil.
REMOVING THE RECHARGEABLE BATTERY
We strongly recommend that a professional removes the rechargeable battery. Parts of the
shaver case, and tools have sharp edges and may cause injury if not handled correctly.
•
The rechargeable battery must be removed from the appliance before it is scrapped.
•
Disconnect the charging adapter before removing the battery.
1.
Remove the shaver head (pull the head up and off).
2.
Using a small screwdriver, pry the front panel off the handle.
3.
Unscrew the 3 screws located on front of shaver.
4.
Using a small flat screwdriver, pry the front housing from the body.
5.
Unscrew the 6 screws to open the inner housing.
6.
Take out the circuit board.
7.
Disconnect the battery from the circuit board.
•
The battery must be disposed of at an appropriate official recycling/collection point.
•
Do not attempt to operate the shaver once you have opened it.
6
Publicité
Table des Matières
