Gardena EasyCut 400 Mode D'emploi page 6

Trimming overhanging
lawn edges :
Starting the trimmer :
K
L
Filament feed
(Tip mechanism) :
ComfortCut 450 / PowerCut 500 :
1. Setting the plant guard
to parking position (see
"Adjusting the plant guard" ).
2. Set handle angle to position 3
(see "Setting the working
position" ).
I
3. Push slider
J
turn handle
I
and let slider
place (see arrows
articulated fork and handle
holder).
EasyCut 400 / 480 :
v Open clamping lever
turn upper part of handle
through 180° and close
clamping lever
Switching the trimmer on :
1. Press and hold the safety lock
the start button
2. Release the safety lock
Switching the trimmer off :
v Release the start button
The tip mechanism works when the motor is running. A clean
cut is only achieved with the maximum filament length.
1. Start the trimmer.
2. Hold the cutting head
parallel to the ground and
tap the trimmer with the
2
cutting head
ground (avoid sustained
2
pressure).
The cutting filament
switching process and adjusted to the correct length with the fila-
N
ment limiter . If necessary tap several times one after the other.
H
upwards,
through 90°
lock into
z
on
P
E
,
8
E
again.
E
K
and then press
L
on the handle.
K
again.
L
on the handle.
2
on the
M
is automatically lengthened with an audible
J
z
P
I
H
8
N
M
15