Charging The Battery Pack - Kenwood TK-D240 Guide De L'utilisateur

CHARGING THE BATTERY PACK

ATTENTION:
◆ Always switch OFF a transceiver equipped with a battery pack
before inserting the transceiver into the charger.
1 Plug the AC adapter cable into the jack located on the rear
of the charger.
2 Plug the AC adapter into an AC outlet.
3 Slide a battery pack or a transceiver equipped with a battery
pack into the charging slot of the charger.
• Make sure the metal contacts of the battery pack mate securely
with the charger terminals.
• The indicator lights red and charging begins.
4 When charging is completed, the indicator flashing green.
Remove the battery pack or the transceiver from the
charging slot of the charger.
• It takes approximately 3 hours to charge the battery pack.
• When the charger will not be used for a long time, unplug the AC
adapter from the AC outlet.
Note:
◆ When the indicator blinks red, the battery pack is either defective or
the battery pack contacts are not properly mated with those of the
charger.
◆ When the indicator flashes green and orange, the battery pack has
not satisfied the charging start temperature. Remove the battery
pack from the charger and wait until it reaches a normal temperature
before charging it again.
◆ The ambient temperature should be between 41°F and 104°F (5°C
and 40°C) while charging is in progress. Charging outside this
range may not fully charge the battery.
14
Indicator