Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.6
Additional safety instructions
▶ Do not use the product if the supply cord and/or the plug is damaged. Make sure that supply cord and
extension cord are not exposed to moisture and/or damp. Do not touch the supply cord if it is damaged
while work is in progress.
▶ Before starting, check all filters and seals and replace damaged filters. Operate the product only with
approved filters (pre-filters and main filters) installed.
▶ Do not allow water to collect in the hollow of the grip. Clean the drain hole at regular intervals.
▶ Whenever the room is occupied, always operate the product at the highest power level.
▶ Make sure that the main-filter frame is securely installed and correctly seated.
▶ Do not use the air filter in the vicinity of flammable and explosive gases.
▶ Wear protective gloves for working with hot materials and for carrying out maintenance tasks on the
product.
▶ Make sure that the air cleaner is so steady that there is no risk of it tipping over.
▶ When the product starts up, it produces a strong current of discharged air. This can swirl up dust in the
product's immediate vicinity.
▶ Always switch the product off at the main switch! The start-up capacitor can carry an electrical charge
even after the plug has been disconnected from the power outlet.
▶ Do not use the product to filter hot or incandescent fragments or particles. Make sure that the temperature
of the inducted contaminated air does not exceed 60 °C.
▶ Do not permit the product to become overloaded or blocked because of an overfilled filter. Further
operation is no longer possible as soon as the indicator lamp lights up.
▶ To reduce the risk of injury use only genuine Hilti accessories and spare parts or those of equivalent
quality.
▶ Before beginning cleaning and maintenance work, switch the product off and unplug it from the power
outlet. Before you open the filter cover, wait until the turbine has come to a complete stop.
▶ Do not transport the product by crane or with hoists.
▶ Do not stand on the product (do not use it as a substitute for a ladder).
▶ Connect the product only to a properly earthed/grounded power source.
▶ Before you unplug the supply cord of a power tool from the product's electric tool power outlet, always
first disconnect the product from the main electricity supply.
▶ Store the product and its accessories in dry rooms. Keep it out of reach of children.
3
Description
3.1
Product overview
4
English
1
Pushbar release button
@
Pushbar
;
Pre-filter cover
=
Carrying handle
%
Filter change indicator light
&
On/Off switch
(
Transport hook for supply cord
)
Supply cord
+
Discharged-air outlet
§
Main filter
/
Pre-filter
:
Toggle catch (housing cover)
∙
Shutter
$
Dust-stop partition wall adapter
£
Cover for air inlet
|
2297302
*2297302*
Publicité
Table des Matières
