Maintenance Schedule; Maintenance - McCulloch B40 B Elite Manuel D'utilisation

3. Move the product from side to side when you cut
grass. Use full speed.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.

Maintenance schedule

Maintenance

Clean the external surface.
Examine the harness for damages.
Do a check of the throttle trigger lockout and the throttle trigger. Refer to
check of the throttle trigger lockout on page 7 .
Examine the handle and the handlebar for damages and make sure that they are
attached correctly.
Do a check of the stop switch. Refer to
8 .
Make sure that the cutting attachment does not rotate at idle speed.
Clean the air filter. Replace it if it is damaged.
Examine the cutting attachment guard for damages and cracks.
Make sure that the saw blade or grass blade is attached correctly. Make sure
that the saw blade or grass blade is sharp and not damaged.
Examine the trimmer head for damages and cracks. Replace it if it is damaged.
Tighten the locknut fully for cutting attachments with a locknut.
Examine the transport guard for damage and make sure that it can be attached
correctly.
Tighten nuts and screws.
Examine the engine, the fuel tank and the fuel lines for leaks.
1681 - 001 - 28.06.2021
Maintenance
Read and understand the
To do a check of the stop switch on page
To sweep the grass
The airflow from the rotating trimmer line can be used to
remove cut grass from an area.
1. Hold the trimmer head and the trimmer line parallel
to the ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and sweep
the grass.
WARNING:
cover each time you assemble new trimmer
line to prevent unbalance and vibrations in
the handles. Also do a check of the other
parts of the trimmer head and clean it if
necessary.
To do a
Clean the trimmer head
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
21