Unpair; Pairing The Wireless Direct Wire Wall Switch With The Brematicpro Gateway; Factory Reset; Cleaning The Device - brennenstuhl BrematicPRO UPWS 868 01 W1000 3726 Mode D'emploi

Unpair

Press and hold the pair button for 3 seconds.
The LED will flash red.
Whilst the LED is flashing, press the respective button on the
right of the BrematicPRO wireless remote control you wish to
unpair. This completes the unpairing process.
Pairing the Wireless direct wire wall switch
with the BrematicPRO Gateway
When linked with the Home Automation Systems BrematicPRO via
the BrematicPRO Gateway, you can use the app / BrematicPRO PC
software to use additional software-based functions, e.g. functions
such as controlling actions (tasks), switching devices on / off.
The app or BrematicPRO PC software is installed and open.
The BrematicPRO Gateway is ready for use.
Keep the device at least 50 cm from the Gateway.
Open the "Settings" menu.
Select the room where you wish to use the device.
Select the frequency "868 MHz".
Select "Add Device".
Under "New Device", select "Switch / Socket" and click "Continue"
to confirm your selection.
Follow the on-screen instructions.
Press the upper or lower part of the rocker switch on the wall
switch. Only one rocker switch has to be programmed for the
wall switch to be fully integrated within the system.
Enter a device name, e.g. "Living Room Lamp".
Select "Add" to assign the device to the room.
First tap "Back" to leave the room, then "Done" to complete the
pairing process.
The wireless direct wire wall switch is now connected to the
Home Automation Systems BrematicPRO.
Wireless direct wire wall switch 868.3 MHz
Use "Test Device" to switch the consumer on and off to ensure
the wireless direct wire wall switch is working properly.
In this submenu you can also add the device to your favourites.
For more information about the app and how to use it, please visit
our homepage at: www.brematic.com/en/service.

Factory Reset

The device can be restored to the factory settings at any time. A reset
will be required if malfunctions occur.
Press the pair button for at least 6 seconds.
The LED will flash rapidly and go out after approx. 3 seconds.
The device has been reset.

Cleaning the Device

DANGER! RISK OF ELECTRIC SHOCK!
Disconnect the device from the mains before cleaning.
Do not allow liquids to enter the device. Liquids entering can result in
a short circuit.
Clean the device with a dry, lint-free cloth. For tough dirt, you
may also slightly dampen the cloth.
Do not clean with solvent-based cleaners. These could damage
the device surface and markings.
Never immerse the device in water or other liquids. The product
may otherwise be damaged.
Ensure the device is completely dry before using it again.

Action

Problem Possible cause
LED doesn't flash. Device has not
been installed cor-
rectly.
The circuit breaker
is not switched on.
The device won't The remote control
switch on. is outside the range
of the Gateway /
the wireless com-
ponent.
Device not de- The device is out-
tected. side the Gateway
range.
Action
Have installation
carried out correctly.
Check if there is
power. Switch on
the circuit breaker.
Reduce the distance
to the Gateway /
wireless component.
Reduce the distance
to the Gateway.
EN 13