Built-In Cd Player; Display And Indicators; Basic Operation - Pioneer DEH-P90HDD Mode D'emploi

Built-in CD Player

D
isplay and indicators
FORM 1
q
FORM 2
q
e
qSource name
wTrack number
eDisc title
rPlay time
tTrack title
B
asic operation
The built-in CD player plays one standard 12
cm or 8 cm (single) CD at a time. Do not use an
adapter when playing an 8 cm CD.
1. Press OPEN to open the front panel.
2. Insert a CD into the CD loading slot.
CD loading slot
3. Close the front panel.
19
w
e r
w r
t
CD EJECT button
4. Press VOLUME to extend the VOLUME
outward.
• When you press VOLUME, it extends out-
ward so that it becomes easier to turn. To
retract VOLUME, press it again.
5. Turn VOLUME to adjust the volume.
6. Press 2 2 or 3 3 to select a track.
Pressing 3 skips to the start of the next
track.
Pressing 2 once skips to the start of the cur-
rent track. Pressing again will skip to the
previous track.
• If you press and hold 2 or 3, you can per-
form fast forward or reverse.
7. Press OPEN and then press CD EJECT to
eject the CD.
• Be sure to close the front panel after
removing the CD.
WARNING:
• Do not use with the front panel left open. If the
front panel is left open, it may result in injury
in the event of an accident.
Note:
• You can select CD as the source by pressing
SOURCE when a disc is loaded in this product.
• When the front panel is open, multi-function but-
tons are not available.
• Do not insert anything other than a CD into the CD
loading slot.
• A CD left partially inserted after ejection may incur
damage or fall out.
• If a CD cannot be inserted fully or playback fails,
make sure the recorded side is down. Press the CD
EJECT and check the disc for damage before rein-
serting it.
• If the built-in CD player cannot operate properly, an
error message (such as "ERROR-12") appears on
the display. Refer to "Understanding built-in CD
player error messages" on page 74.