Dab Mode; Operating The Radio; Selecting A Station; Secondary Services - PERFECTPRO POWER-PLAYER Manuel De L'utilisateur

DAB MODE

Operating the radio

1. Carefully extend the antenna. Press the Power button to switch on the radio.
2. If this is the first time to switch on, the radio will be in DAB mode.
3. The first station (in numeric-alpha order 0...9...A...Z) in the list of stations found will
be played. The display will show the station name.
If the radio has been used before, the last used station will be selected.
4. If no signals are detected, "No stations found" will be displayed. It may be
necessary to relocate the radio to a position giving better reception.
You should then carry out an auto scan to find stations, please refer to the section
"Find new stations - DAB".

Selecting a station

1. Press the Power button to switch on the radio.
2. The display shows the name of the radio station currently selected.
3. Rotate the Tuning / Select knob to scroll through the list of available stations.
4. When the desired station name appears on the display, press the Tuning / Select
knob to select the station. The display will show the station name while playing.
Note: If after selecting a station the display shows "Service not available", it may be
necessary to relocate the radio to a position giving better reception.

Secondary services

1. Certain radio stations have one or more secondary services associated with them.
If a station has a secondary service associated with it, then the secondary service
will appear immediately after the primary service as you turn the Tuning / Select
knob.
2. Press the Tuning / Select knob to select the secondary service.
Most of secondary services do not broadcast continually and if the selected service
is not available, the radio will re-tune to the associated primary service.
11

Display modes

In DAB mode, the radio can display a range of information on the display.
Press the Info button to cycle through the various modes.
a. Scrolling text Displays scrolling text message such as artist/track
name, phone in number, etc.
b. Program type Displays type of station being listened to e.g. Pop,
classic, News, etc.
c. Signal strength Displays the signal strength of radio reception.
The clear unfilled rectangle indicates minimum
signal level required for satisfactory reception.
d. Multiplex name & frequency Displays name of multiplex to which the current
station belongs. And to displays channel number
and frequency for the currently tuned DAB station.
e. Bit rate & audio type Displays the digital audio bit rate.
f. Date Displays the date of today.

Finding new stations

Should you wish to use your radio for DAB reception in a new location, or if no stations
were detected during the initial scan, you can follow this procedure to allow your
Powerplayer to find out which DAB radio stations are available. Also, from time to time,
new stations may become available. You may proceed to find new stations as follows:
1. Press the Source button to DAB mode.
2. Press the Tuning / Select knob, the radio will perform a scan of the Band III DAB
channels.
As new stations are found, the station counter on the right-hand side of the display
will increase and stations will be added to the list.

Manual tuning

Manual tuning allows you to tune the radio directly to various DAB Band III channels.
1. Press the Menu button, the display shows "Manual tune", then press the Tuning /
Select knob.
2. Rotate the Tuning / Select knob to select the desired DAB channel. Press the
Tuning / Select knob to tune the chosen frequency.
3. The signal strength display with an open bar shows the minimum signal strength
needed for good DAB reception. The signal strength bars will go up or down
showing the changing signal strength as you adjust the antenna or the radio
position.
GB
GB
12