Pairing Mode Of The Bluebull Speaker; Aux In Mode; Volume - PERFECTPRO BLUEBULL Mode D'emploi

Pairing mode of the Bluebull speaker

1. Press and hold the POWER button for about 2 seconds to turn on the Bluebull
speaker.
2. The default mode is Bluetooth.
3. Press and hold the PAIR button for about 2 seconds.
4. The Bluetooth of the Bluebull speaker will be disconnected from your current
connected mobile device and then enter the "discoverable mode".
5. In your mobile device open the Setting menu and select Bluetooth, then select
"BlueBull" in the Bluetooth device's list (Bluetooth pairing instructions may vary per
type of mobile device, please check your mobile device manual).
6. The Bluetooth connected LED will start blinking until the new paring is established.
NOTE: This will allow the Bluebull Bluetooth pairing to another device. If no new device
is paired, the Bluebull will automatically try to connect to the last connected device after
no Bluetooth connection for 1 minute in Bluetooth mode or after the Bluebull speaker is
switched off and on again.
NOTE: The Auto-Power management function will be activated in Bluetooth mode.
If there is "Not connected" for a period over 15 minutes, the Bluebull speaker will
automatically switch to standby mode. Press and hold the POWER button for about 2
seconds will wake up the Bluebull speaker to the Bluetooth mode.
AUX-IN MODE
A 3.5mm stereo AUX-IN socket is provided at the back behind the rubber cover, for
connecting an external audio device such as a MP3 player or a CD player (not included
with the Bluebull speaker).
1. Connect an audio source to the AUX-IN socket with an AUX cable (not included).
2. Turn on the Bluebull speaker by pressing and holding the POWER button for about
2 seconds.
3. If the Bluebull speaker is in Bluetooth mode with either Bluetooth connected LED
on or flashing, press and hold the EQ/MODE button for about 2 seconds to select
AUX input.
4. When the Bluebull speaker is in AUX-IN mode, the red AUX LED will be lit.
5. Play the external player.
6. Adjust the volume of both the Bluebull speaker and the player for comfortable
listening.
7. After use, close the rubber cover to prevent moist or dust from entering into the
socket and Bluebull speaker.
WARNING: Never use the AUX-IN socket in rainy or moist conditions to prevent
moist from entering the Bluebull speaker. Keep the rubber cover well closed
under these conditions.
9
NOTE: The Auto-POWER management function will be activated in AUX-IN mode. If
there is no signal from the AUX-IN socket for a period over 15 minutes, the Bluebull
speaker will automatically switch to standby mode. The operation indicator and the LED
will go off in such case. Press and hold the POWER button for about 2 seconds, this
will wake up the Bluebull speaker to the Bluetooth mode.

VOLUME

To adjust the volume, simply press the VOLUME – or VOLUME + buttons when playing
Bluetooth or AUX-IN mode. When the Bluebull speaker reaches the maximum volume
level, the red VOL. MAX LED will flash 3 times.
For maximum power output also put the volume of your mobile device to
maximum.
The volume setting on your mobile device will act as the master volume.
SAFETY AND COURTESY NOTE: To prevent possible hearing damage, do not listen at
high volume levels for long periods or put your ears too close to the Bluebull speaker.
Please use the volume level responsibly with respectable consideration of the situation
and other people in the vicinity.
NOTE: When playing on battery power and the energy level of the battery is too low, the
sound may distort on higher volume.
GB
G B
10