Gear-drive eccentric sander
Technical data
Power
Speed
Sanding stroke
Weight according to
EPTA-Procedure 01:2014
The specified illustrations can be found at the
beginning of the operating instructions.
Graphical symbols
Caution. Danger!
Read the operating instructions/notes
Wear ear protection!
Wear protective goggles!
Wear a protective mask!
Disconnect from the power supply!
Do not throw in the household waste!
Safety class II
1
Intended use
As specified, the machines are designed for sand-
ing and polishing wood, plastic, metal, composite
materials, paint/varnish, filler and similar mate-
rials.
Materials containing asbestos must not be pro-
cessed.
For reasons of electrical safety the machine must
not be damp nor operated in a humid environment.
The machine may only be used for dry sanding.
The user is liable for damage and injury
resulting from incorrect usage!
2
Before starting up, please observe the
following
2.1
Safety instructions
WARNING!
instructions, illustrations and specifications
provided with this power tool. Failure to follow
all instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
RO 125 FEQ
500 W
3000 - 6000 rpm
3.6 mm
1.9 kg
Read all safety warnings,
The term "power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
- Harmful/toxic dusts can occur during your work
(e.g. lead-containing paint, some types of wood
and metal). Contact with these dusts, espe-
cially inhaling them, can represent a hazard for
operating personnel or persons in the vicinity.
Comply with the safety regulations that apply in
your country. Connect the electric power tool to
a suitable extraction system.
To protect your health, wear a P2 protec-
tive mask.
Always wear protective goggles because
of possible dangers when sanding.
- The manufacturer's handling and processing
instructions must be observed without fail if
explosive or self-igniting dusts are likely to oc-
cur during sanding.
- Prevent the penetration of liquid polish into
the tool. The penetration of liquid polish into
the power tool increases the risk of an electric
shock.
- If the power tool is dropped or falls, check
for damage to the machine and sanding pad.
Remove the sanding pad for closer inspection.
Repair damaged parts before using again. Bro-
ken sanding pads and damaged machines can
cause injuries and machine instability.
- Only for AS/NZS: The tool shall always be sup-
plied via residual current device with a rated
residual current of 30 mA or less.
2.2
Noise and vibration information
Typically, the noise levels that are determined in
accordance with EN 62841 (see EC declaration of
conformity) are as follows:
Sound pressure level
Sound-power level
Measuring uncertainty allowance
Wear ear protection!
Vibration emission value ah (vector sum for three
directions) and uncertainty K measured in ac-
cordance with EN 62841 (see EU Declaration of
Conformity):
Fine sanding
Coarse sanding
Polishing
The specified emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
11
79 dB(A)
90 dB(A)
K = 3 dB
a
= 5.7 m/s²
h
a
= 3.4 m/s²
h
a
= 5.8 m/s²
h
K = 1.5 m/s²