FOCOLARI in ghisa
3.
REGULATIONS FOR INSTALLATION
Your usual local chimney sweeper has to be informed of the installation of this equipment, in order to verify the correct
connection of the same to the stack.
Before the installation perform the following checks:
•
Make sure that the floor can support the weight of the device and provide for a proper insulation in case it is
built using flammable material.
•
Make sure that in the room where it will be installed there is a proper ventilation (presence of air intake)
•
Avoid the installation in rooms with presence of common ventilation ducts, hoods with or without extractor, gas
devices of type B, heat pumps or the presence of devices whose simultaneous operation can cause depression
in the room (Ref. Standard UNI 10683/98)
•
Make sure that the flue and the pipes to which the device will be connected are suitable for the operation of the
same.
•
Always leave at least 10cm of air pocket between the appliance and
Is recommended that you have your local usual chimney sweeper check both the connection to the stack and the
sufficient air inflow for the combustion in the installation room.
After testing the proper working of the appliance, some days from the installation, it is possible to proceed
with the construction of its aesthetic covering.
WARNING: During the surround building operations it must kept in mind possible and subsequent electrical installed
parts maintenance (Fans, temperature probe, etc) and with hydraulic systems all parts connected to the Thermo
product.
4.
FIRE-FIGHTING SAFETY MEASURES
Nell'installazione dell'apparecchio devono venire osservate le seguenti misure di sicurezza:
a) In front of the hearth there must not be any flammable object or construction material sensitive to heat within a
distance of 80 cm;
b) Should the device be installed on a floor made of not completely refractory material, it is necessary to foresee a
fire-resistant foundation, for example a steel footboard (dimensions according to the local regulations.) (Picture
3).
Warn
children
that the
device becomes very hot
and that it must not be
touched.
The fireplace must work
exclusively with inserted ash
drawer.
solid combustion residuals
(ashes) must be collected in
an air-tight and fire-resistant
container. The device must
never be switched on when
there are gaseous emissions
vapors (for example glue for
linoleum, gasoline etc.). Do
not
deposit
flammable
materials close to the same.
4.1.
FIRST-AID MEASURES
Should any fire arise in the stack or in the flue:
a) Close the feeding door.
b) Close the registers of combustion air
c) Extinguish the fire using carbon dioxide fire-fighting means (CO
d) Seek immediate intervention of FIRE BRIGADE.
DO NOT EXTINGUISH FIRE USING WATER JETS.
6097000 – EN
Protection of the floor
with incombustible material
Flooring in
combustible material
Picture 3
the.
A
A= Side limit of the protected area (A=H+20 cm=> 40 cm)
B= Front limit of the protected area (B=H+30 cm=> 60 cm)
dust).
2
Height of the hearth
surface from the
ground
H
B
19