VINCENT SP-998 Manuel D'utilisation page 30

CONNECTION OF THE LOUDSPEAKERS
If no connector is to be used, remove approximately 1 cm length of insulation from each end of the spea-
ker wire. Twist the braid in order to avoid short circuits. Turn the fastener on the loudspeaker terminal coun-
terclockwise to loosen it and introduce the bare wire end into the exposed connector hole. Then turn the
fastener clockwise so that the wire is firmly clamped. Make sure the connection is pretty tight.
Attention:
If you intend to connect two speakers, both loudspeakers must have a nominal impedance of at least 8Ω.
If only one speaker is used, every type of loudspeakers with a minimal nominal impedance of 4Ω can
be utilised.
Consider correct polarity, the positive contact is mostly marked red or with "+". The side of the speaker
cable that has to be connected with the positive socket has a marking.
CONNECTION OF THE POWER CABLE
Check that the electricity supply to your home is appropriate to the device. The required voltage and fre-
quency can be read on the back of the device beside the socket for the mains. If the electricity supply is
appropriate, push the inlet connector of the supplied mains cable firmly into socket for the mains on the
back of the device (7). Connect the other end of the mains cable to a mains socket.
Vincent
30