Care Instructions - Eschenbach Mobilux LED Mode D'emploi

4. After use, switch the LED light off by sliding the shifter (e) in the direction
away from the lens (r).
Note: If the LED flickers, the batteries are drained and must be exchanged for new
ones. In this case, proceed as detailed in the chapter 'Initial device operation'.
If the colour of the light is unpleasant for you, you can place one of the enclosed
LED filter caps (q, orange or yellow) over the LED, as shown in the left figure on
page 3.
To protect the lens your mobiluxLED is supplied with a case.
To enable you to hang your mobiluxLED around your neck it has an eyelet located
on the end of the handle and through which a lanyard, which is optionally available,
can be threaded. (Stock.-No. 15981).

Care Instructions

X When cleaning the mobiluxLED do not use any soap solutions that contain sof-
tening agents, no alcohol-based or organic solvents and no abrasive detergents!
The lenses could be destroyed!
X Do not clean the mobiluxLED in an ultrasonic bath or under flowing water!
X Clean the mobiluxLED with a soft, lint-free cloth (e.g. with a cleaning cloth for
glasses). For heavier soiling (e.g. fingerprints), moisten the cloth slightly.
11