Eschenbach Mobilux LED Mode D'emploi page 10

Initial device operation
For equable illumination of your reading material this mobiluxLED is equipped with
a high-performance LED, which is powered by 2 batteries (AA/LR6). Before the
first use, you must insert the batteries.
1. To do this, open the battery compartment cover (w).
2. Insert 2 batteries into the battery compartment as per the alignments shown
therein. Pay attention to observance of the correct polarities, otherwise the
device will not work.
3. Close the battery compartment.
Using the mobiluxLED
You can use mobiluxLED with your reading glasses.
1. Hold the mobiluxLED with the lens centrally over the text that is to be magnified.
2. The optimal imaging quality with mobiluxLED is to be obtained when you maintain
the distance to the lens determined for you for the magnification used by you. This
value (in mm) is to be found in the chapter 'Technische Daten / Technical Data
/ Caratéristiques techniques' on page 3,
above the switch on your mobiluxLED.
3. Switch the LED light on by sliding the shifter (e) in the direction of the lens (r).
If you require stronger illumination, fit the transparent LED filter cap (q) of the 3
enclosed LED filter caps, as shown in the left figure on page 3.
(Spacing lens-eye) as well as
10