Fitting The Protective Cover; Removing The Protective Cover; Maintenance And Care; Contact Information - CALIMA 46046 Manuel De L'opérateur

5.2 FITTING THE PROTECTIVE COVER

• Remove the protective cover from the storage bag and spread it out on a dry, clean surface. Place the protective sleeve with the right side (with the zips)
facing upwards.
• Open the zips and roll the side part up. Fasten it with the Velcro straps.
• Now lift the protective cover with the open side over the left hand side of the caravan / mobile home,
Figure 1. Use the fi tting aids.
When pulling over, take care that you do not damage roof structures,
exterior mirrors or other parts.
• Align the protective cover on the caravan / mobile home so that it is straight and centred on the roof
of the vehicle.
• Unfurl the rolled side part and close the zips.
• Fasten together the locks of the tensioning straps at the rear and tighten the straps.
• There are stitched on eyelets on the hem of the sides. Knot one end of the tensioning cable on
the rearmost left eye. Pull the loose end of the tensioning cable through the other eyelets of the
protective sleeve, as shown in Figure. 2.
• Carefully tighten the tensioning cable. Make sure that the hem of the protective cover is placed
neatly around the lower edge of the caravan / mobile home. Avoid folds in which water can stay.
Tighten the tensioning cable.

5.3 REMOVING THE PROTECTIVE COVER

• Loosen the tensioning cable and pull it out completely from all of the eyelets.
• Open the zips and roll the side part up. Fasten it with the Velcro straps.
• Check the inside of the seam for dirt (sand, small stones, etc.) before removing the protective cover. Remove any dirt.
• Now remove the protective cover towards the left side of the vehicle.
When removing, take care that you do not damage roof structures, exterior mirrors or other parts.

6. MAINTENANCE AND CARE

Only remove dirt from the protective cover by dry brushing. Do not use detergents or cleaning agents. These can damage the vapour-permeable layer in the
protective cover.
Allow the protective cover to dry completely before storing it in the bag.
7. NOTES REGARDING ENVIRONMENTAL PROTECTION
If the protective cover has worn out or become unusable, dispose of it over the residual waste container.

8. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
6
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
Figure 1: Pulling the protective cover over
Figure 2: Fastening with the tensioning cable