Input Channels - HQ Power VDSSM5 Mode D'emploi

Taking Down
1. Set all volume controls on the control panel [5,24] to zero.
2. Switch off all audio devices.
3. Switch off [27] the mixing console.
4. Disconnect all audio devices and speakers.
5. Store the microphone and cables in the storage compartments [D].
6. Take the speakers off the stands and fold the stands.
7. Place the folded stands in the mixing console and fix them in place using the straps [E].
8. Place the speakers on top of the mixing console and close the four catches [C].
Caution: Do not force. If the catches do not close properly, then carefully reposition the speakers and try
again.
6. Overview
Refer to the illustrations on page 2 of this manual.
Input channels 1–4
1 MIC and LINE inputs.
MIC: microphone input, XLR jack. Connect a low impedance microphone.
LINE: line input, 1/4" jack.
For channels 1–3: mono input.
For channel 4: use connector LEFT/MONO for mono input, or use both LEFT and RIGHT connectors for
stereo input.
Note: use either the MIC or LINE input. Do not use both inputs at the same time.
2 REVERB: apply a reverb effect to this input channel.
3 TREBLE: adjust the high tones. ± 15 dB at 12 kHz.
4 BASS: adjust the low tones. ± 15 dB at 80 Hz.
5 GAIN: set the channel volume. It determines the proportion of this channel in the mix.
Input channel 5
6 Input source selector:
LINE: select input from the TAPE INPUT jacks.
MP3: select MP3 input from a USB device or SD card
BLT: select input from a Bluetooth device.
7 TAPE INPUT: connect an input device such as a cassette deck or CD player to the RCA jacks. The input
can be added to the mix.
TAPE OUTPUT: connect an output device such as a cassette deck or home audio system to the RCA
jacks.
MP3 player with LCD and remote control
8 LCD
9 USB port: insert a USB storage medium.
10 FOL–: press to select the previous folder on the USB device or SD card.
11 FOL+: press to select the next folder on the USB device or SD card.
12 MODE: press repeatedly to select the desired play mode: USB/SD or FM radio.
13 REPEAT: to set up repeat mode.
14
PLAY/PAUSE: use the play/pause button to switch between playback mode and pause mode.
15 EQ: press repeatedly to select the desired equalizer mode: CLASSICAL, BASS, LIVE, ROCK, or POP.
16
VOL–: press to select the previous track. Press and hold to decrease the volume.
17
VOL+: Press to select the next track. Press and hold to increase the volume.
18 Mute key: mutes the volume of the SD/USB player.
V. 01 – 15/11/2013
VDSSM5
5 ©Velleman nv