Locking The Controls - Sony TN-1885T Mode D'emploi

Adjustments
Switching the Input Connector
It is necessary to select the connector type (HD15/5 BNC)
correctly according to the connection.
1
Press the (option) button.
The option OSD (On Screen Display) appears.
2
Press the ¨ ./> buttons to select ... and then press
the >?// buttons to select "1" or "2."
"1" is for the Video input 1 connector (HD15) and "2" is
for the Video input 2 connector (5 BNC).
If you select the Video input 1 or 2 connector and that
connector does not receive any signal, the unit automatically
switches to the other connector.
To erase the OSD, press the
The OSD automatically disappears 30 seconds after you
release the buttons.
To reset, press the ? (reset) button while the OSD is on.
8
1 2
80.0KH / 75H
Z Z
button again.

Locking the Controls

Locks the monitor so that the buttons, except the u power
switch and (option) button, on the front panel cannot be
operated (Lock mode). With this function, you can ensure
that the display remains in the optimum condition even
when the monitor is placed where the control buttons can
be touched by unauthorized persons.
To release the Lock mode, set it to off (
Normally keep this function set to off (
1
Press the (option) button.
The option OSD (On Screen Display) appears.
2
Press the ¨. button to select "
> ?// buttons to select "
The ¨ ./> buttons do not work on the option OSD.
The control buttons on the front panel except the u power
switch and (option) button do not work. If you press any
button, the mark appears on the screen.
To Cancel the Control Lock
Press the > ?// buttons to select "
To erase the OSD, press the
The OSD automatically disappears 30 seconds after you
release the buttons.
) position.
) position.
1 2
80.0KH / 75H
Z Z
" and then press the
."
."
(option) button again.