Setting The Power Saving Delay Time; Locking The Controls - Sony Trinitron CPD-520GST Mode D'emploi

Customizing Your Monitor

Setting the power saving delay time

You can set the delay time before the monitor enters the
power saving mode. See page 19 for more information on
this monitor's power saving capabilities.
1
Press the MENU button.
The MENU OSD appears.
MENU
2 Press the ¨./> and >?// buttons to select "
OPTION," and press the MENU button again.
The OPTION OSD appears.
3 Press the ¨./> buttons to select "
DELAY)."
4
Press the >?// buttons to select the desired time.
When PWR SAVE DELAY is set to "OFF," the monitor
does not go into power saving mode.
The OPTION OSD automatically disappears after about 30
seconds.
To close the OSD, press the MENU button again.
To reset, press the RESET button while the OSD is on.
16

Locking the controls

The control lock function disables all of the buttons on the
front panel except the u (power) switch, MENU and INPUT
buttons.
1
2
OPTION
ON
ZZ...
1 MIN
UNLOCK
MANUAL DEGAUSS
3
ZZ...
(PWR SAVE
OPTION
AUTO
5 SEC 1 MIN
ZZ...
60 MIN OFF
PWR SAVE DELAY
4
The OPTION OSD automatically disappears after about 30
seconds.
To close the OSD, press the MENU button again.
Once you select "LOCK," you cannot select any items
except "EXIT" and "
If you press any button other than the u (power) switch,
MENU and INPUT buttons, the
screen.
To cancel the control lock
Repeat steps 1 through 3 above and press the >?//
buttons to select "UNLOCK."
Press the MENU button.
The MENU OSD appears.
MENU
Press the ¨./> and >?// buttons to select "
OPTION," and press the MENU button again.
The OPTION OSD appears.
Press the ¨./> buttons to select "
LOCK)."
Press the >?// buttons to select "LOCK."
OPTION" in the MENU OSD.
OPTION
ON
ZZ...
1 MIN
UNLOCK
MANUAL DEGAUSS
(CONTROL
OPTION
AUTO
ZZ...
UNLOCK LOCK
CONTROL LOCK
mark appears on the