Power Saving Function - Sony TN-1885T Mode D'emploi

Power Saving Function

This monitor is capable of 3 states of reduced power
consumption.
Mode State
Normal operation
1
Standby
2
(1st step of power saving)
Suspend
3
(2nd step of power saving)
Active-off
4
(3rd step of power saving)
Power-off
5
• If any or both indicator is flashing, please cycle the power
switch once. If they are still flashing, there is a potential
monitor failure.
Please note which function indicator is lit, unplug the AC
cord, and contact your service representative.
• If there is a signal source input to both video 1 and 2
connectors, the power saving function acts on the input
signal with the higher power consumption as in the table
above.
Power Saving Operation
• The H-sync is not present.
/ The unit goes into standby state.
• The V-sync is not present.
/ The unit goes into suspend state.
• Both the H-sync and V-sync are not present.
/ The unit goes into active-off state.
10
By sensing the absence of video signals and one or both
sync signals coming from the host computer, it will reduce
power consumption as follows:
Power consumption
resumption time
≤ 140 W (TN-1885T)
≤ 150 W (TN-2185T)
≤ 100 W
approx. 3 sec.
≤ 15 W
approx. 3 sec.
≤ 5 W
approx. 10 sec.
0 W
The monitor requires a videocard or screen saver software
which switches off one or both sync signals to activate the
power saving function.
Caution: The Power Saving function will automatically put
(power saving)
Required
indicator
off
—
orange on
orange on
orange on
off
—
the monitor into the Active-off state and the
power saving indicator will be lit if the u power
switch is turned on without any video signal
input. Once the horizontal and vertical syncs are
sensed, the monitor will automatically return to
its Normal operation state.
u (power)
indicator
green on
green on
green on
off
off