Agri-Fab 45-0518 Notice D'utilisation page 7

15. Turn the lift handle as shown in figure 11 and attach it
to the side of the lift lever that is indicated. Use a 1/2"
x 1-1/4" hex bolt (C) and 1/2" nylock nut (M) in the
bottom hole and the clevis pin (P) and small hairpin
cotter in the top hole. Tighten the bolt and nut. See
figure 11.
16. Push the grip (W) onto the lift handle. See figure 11.
1/2" x 1-1/4"
HEX BOLT (C)
FIGURE 11
GRIP (W)
SMALL HAIRPIN
COTTER
LIFT LEVER
1/2" NYLOCK
NUT (M)
ENGLISH
17. Perform the following steps in sequence to tighten the
bolts and nuts that remain loose. Refer to figure 12.
a. Turn the aerator upright, then lock the lift handle
into the transport position.
b. Tighten the eight bolts at the corners of the tray.
c. Tighten the two bolts which fasten the middle
brace to the bottom of the tray.
b
b
FIGURE 12
7
b
b
c