Sony Trinitron Wega KV-DB34 Mode D'emploi page 7

d) If you wish to edit the channels, press
to change to edit mode.
Press b until the mode that you wish to edit
is highlighted: Label, Skip,
Then press
1) To label, press V or v to select the
alphanumeric characters for the label.
Then press
2) To skip the program number, press V or v to
select "On". Then press
You can skip this program number when
using PROG +/-.
3) To block unwanted program number,
press V or v to select . Then press
e) Repeat step b) to d) if you wish to change other
channels.
Press WEGA GATE to go to the next menu.
4
Press B or b to adjust the bars on the
top and bottom of the menu if they are
slanted, then press
"Picture V-Position" menu appears.
5
If the upper and lower bars are not
equally positioned to the top and
bottom of the screen, press V or v to
adjust them, then press
If no adjustment is necessary, then press
6
To prevent this "Initial Setup" menu from
appearing again when you turn on the TV
by pressing !, press V or v to select "No",
then press .
To allow this menu to appear again, select
"Yes", then press
Tip
• You can immediately go to the end of the "Initial Setup" menu by pressing WEGA GATE.
Note
• Before adjusting "Picture Rotation" and "Picture V-Position", keep external speakers or other
electrical equipment away from the TV. The magnetic disturbance from these equipments or
the direction of the earth's magnetic field may affect the TV.
(block symbol).
.
.
.
.
.
.
05
Select
05
Select
.
Select
Select
Select
.
Select
Exit
Confirm
Confirm Exit
Exit
Confirm
Confirm End
End
Confirm
Confirm
7
Installation