Turntable Installation - Signature SMO 250IX/2 Instructions D'utilisation

Turntable Installation

Hub (underside)
Glass tray
Turntable shaft
a. Never place the glass tray upside down. The glass tray should never be restricted.
b. Both glass tray and turntable ring assembly must always be used during cooking.
c. All food and containers of food are always placed on the glass tray for cooking.
d. If glass tray or turntable ring assembly cracks or breaks, contact your nearest
authorized service center.
Installation and connection
1.This appliance is only intended for domestic use.
2.This oven is intended for built-in use only.It is not intended for counter-top use or for use
inside a cupboard.
3. Please observe the special installation instructions.
4.The appliance can be installed in a 60cm wide
wall-mounted cupboard(at lease 55cm deep and 85cm
off the floor).
5.The appliance is fitted with a plug and must only be
connected to a properly installed
earthed socket.
6.The mains voltage must correspond to the voltage specified on the rating plate.
7.The socket must be installed and connecting cable must only be replaced by a qualified
electrician.If the plug is no longer to accessible following installation,an all-pole
disconnecting device must be present on the installation side with a contact gap of at
lease 3mm.
8.Adapters,multi-way strips and extension leads must not be used. Overloading can result
in a risk of fire.
The accessible surface may be hot during operation.
Turntable ring assembly
-40-