Play Mode; Auxiliary Input - Ricatech RTT88 Mode D'emploi

4. Repeat step 2-3 to select and store all desired tracks. FULL is displayed if you attempt to program
more than 20 tracks
P
CD
5. Press PLAY/PAUSE/
Erasing the programme
You can erase the contents of the memory by :
- once if in stop position, twice during playback
- Press POWER
- Select another sound source

Play mode

1. Press REPEAT /
2. Default Play Mode function is OFF.
3. REPEAT 1 / REPEAT FOLDER / REPEAT ALL . THREE kinds of Play Mode can be chosen in
MP3 type.
X-BASS
Press the X-BASS ON/OFF to ON or OFF the X-BASS effect(Adjust the volume level to mid to maxi-
mize the X-BASS effect).
Line Out Outputs
1. You can connect this unit to different sources using the auxiliary output jacks.
2. Connect the auxiliary cables (not supplied) to the LINE OUT JACK and to the auxiliary inputs of the
desired component. See the owner's manual for the operating instructions for the desired
component. The LINE OUT JACK only output a signal and will not run external speakers without
using a separate amplified source.

Auxiliary Input

1 You can connect external components to your unit by using the Auxiliary Input.
2 Plug Auxiliary cable into the LINE IN JACK on the back of your unit.
3 Switch the LINE IN SWITCH to the ON position.
4 Plug the other end of the Auxililary cable into the output jack on your desired external component.
5 Check the volume level of your external component.
6 See operators manual for correct operation of the external component.
NOTE: When not using the Auxiliary Input, make sure the LINE IN SWITCH is in the OFF position.
MP3 copying
1. In USB or SD card playback, Press REC/ERASE/
SD card to USB.Playback will be stopped and system will scan the contents of USB/SD card and
create folder to store MP3 track.
2. icon " REC " displayed
to play the program.
on remote at Play mode.
to start Mp3 copying from USB to SD card or