Ricatech RTT88 Mode D'emploi page 6

Unpacking
1 packing materials from unit.
Note: Save all packing materials.
2 Remove plastic bag covering radio.
3 Remove tie from A/C cord and untie antenna wire on back of radio.
4 Open lid and remove styrofoam shipping material from turntable.
5 Remove black tie-wrap from under the tone arm.
6 Remove white protective needle cover by gently pulling towards the front of the unit.
Remarks:
a) ESD remark: In case of malfunction due to electrostatic discharge, just reset the product
(reconnect of power source may be required) to resume normal operation.
b) Electrical Fast Transient (Burst) Remark (I2): In case of malfunction due to electrical fast transient
(Burst), just reset the product. (reconnect of power source may be required) to resume normal
operation.
SETUP
1. Unwind the AC POWER CORD at the back of unit.
2. Untie the FM antenna and allow it to hang down in a straight line for optimum FM reception. If you
have trouble tuning a FM station, move the external FM antenna for best reception. Do not connect
FM antenna to outside antenna.
Power Source
1. Plug the A/C cord into appropriate outlet.
Radio Operation
1. Set the Function switch to RADIO.
2. Switch the unit ON by turning the VOLUME knob to the on Position.
3. Turn the VOLUME control in mid-range position.
4. Slide the Band switch to the desired band (AM or FM or FM.ST).
5. Select the desired radio station by rotating Tuning Knob
6. Adjust the Volume Knob to the desired sound level.
Antenna
Antenna: for FM reception, the unit is provided with a FM WIRE ANTENNA, move the wire until the
reception is clear and with no interferences. For AM reception, the unit is provided with a directional
build-in ferrite antenna. Rotate the set to find the position in which the best reception is obtained.
Do not connect the EXTERNAL FM ANTENNA to any outside antenna.
USB & SD-CARD OPERATION
SD-Card operation:
1. Slide THE FUNCTION Switch to SD/USB mode.