Initial Operation; Installation; Air Connection / Lubrication - Josef Kihlberg 561PN22 Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Josef Kihlberg c.561PN22

KUDA PACKAGING

5.1 INSTALLATION

The top stapler is delivered without the compressed

air nipple assembled. Assemble the nipple as follow-

ing:

1. Take the stapler out of the box. Check that the

nipple is the correct brand and fits your air sys-

tem. Put sealing compound at the threadle.

(Fig. 2/1).

Install compress air nipple manually until a resistance

is perceptible. Use hexagon ring spanner to tighten 1

1/2 turn..

Lay the compressed air hose so there is

no risk of tripping over it.

5.2 AIR CONNECTION / LUBRICATION

Properly prepared compressed air is essen-

tial for trouble free operation of the stapler.

This can only be ensured by a reliably functioning

maintenance unit, consisting of water separator, pres-

sure reducing valve with pressure gauge. The internal

diameter of the pipe should be at least 10 mm (

Never exceed the maximum permitted air

pressure of 7 bar (102 psi). The maximum

supply pressure is 7 bar (102 psi).

Adjust the working pressure to 5,0–6,0 Bar

(73–87 psi).

A low air pressure will give low maintenance costs!

The stapler and the hose must have a coupling which

automatically bleeds all air pressure from the stapler

when it is disconnected.

The stapler needs a small amount of lubricating oil in

the nipple each day or approx. 10 drops once a week

to ensure safe functioning and endurance. For high

frequency stapling we recommend oil mist lubricator.

Please contact our agent for advice.

733007 Lubrication oil 0.2 dl. (Fig.3/1)

Sliding parts are greased, with Dow Corning grease

MS 4 Silicon Compound, at the factory. We recom-

mend use this grease on moving parts if they have

been cleaned or replaced.

184943 Tube of MS 4. (Fig. 3/2)

SERVIS A NAHRADNÍ DÍLY

www.kuda-packaging.com