Skil PWRCORE 20 SR6607B-00 Guide D'utilisation page 12

Backing Pad Removal/Installation
Your brushless compact multi-sander is
equipped with a hook-and-loop rubber backing
pad that may be removed and attached without
the need for additional tools.
To remove, push the button for changing the
foot plates and pull the backing pad free from
the sander (Fig. 4).
Rotating Backing Pad
For maximum use of the sandpaper, rotate the
pad 120 degrees when the tip of the sandpaper
becomes worn (Fig. 5).
Installing Sandpaper
Your sander uses hook-and-loop backed
sandpaper, which firmly grips to the backing
pad when applied with moderate pressure.
To change, peel off the old sandpaper, remove
any dust from the backing pad, and press
the new sandpaper in place. Be sure to align
the holes in sandpaper with the holes in the
backing pad to allow the dust extraction system
to function (Fig. 6).
12
Fig. 4
1
Fig. 5
Fig. 6
2