Decommissioning, Disposal; Technical Data - flamco Flamcomat Installation Et Mode D'emploi

4. Decommissioning, disposal
Voltage isolation (disconnecting the plugged power supply cable from the socket) interrupts the Easycontact control function.
Switched outputs due to active error (normally open contact: "ON") return to their original state (normally closed contact: "ON"). If the
signal cable is interrupted before power supply is isolated, any existing error messages will still be kept (memory). External supplies
must be de-energised (terminals X3). If you want to dispose of this electronic component, please do so in line with the requirements
of the appropriate waste-disposal company.
5. Technical data
Appliance (name plate)
Rated operating voltage
Frequency
Rated short-circuit current
Load current
Protection class
Degree of protection
Inputs
Outputs
K1 K2 K3
1 2 3 4 5 6 7 8
Attention
Despite isolating from the mains,
the terminals for X3 can still be energised with
a voltage of 240VAC (external power supply).
8
230 VAC (Limit value: min. 100VAC; max.300VAC)
50/60 Hz
0.16 A
0.16 A
IP54
II (protective insulation)
Main supply
mains supply
Netzanschluss
230VAC
L
N
PE
x1
RS485
COM
x2
x3
K4 K5 K6 K7
9 10 11 12 13 14 15 16 17 18 19 20 21
Terminal X1
Power supply
(Installed
by customer)
Signal Terminal X2
(Installed
by customer)
Terminals X3
Relay contacts
(Evaluation,
Installation
as per
requirements)
Spring clips (releasable through pressure on
actuator, colour orange, e.g., with
screwdriver, blade <= 4mm).
L; N. (PE present, but open);
Rated voltage 230 VAC; 50/60 Hz;
Circuit breaker plug - power connecting line
2-wire (possible without PE).
Spring terminals; B (Signal B), A (Signal A).
Data line: Minimum requirement LiYCY TP
(CU wire, insulated, paired with Cu shielding).
Shielding connected to the control unit on
one side (GND). Control unit signal output via
optional screw terminals or connections with
polarised sockets, AMP Modu IV
No.102241-2 (Type: Tyco).
Recommendation:
Avoid supply lines longer than 500 m
(data security, interference).
Spring terminals, potential free.
AC max 240 V; 1 A;
DC max. 125 V; 0.5 A; ohmic load.