WMF LINEO Mode D'emploi page 13

Note: The switch-on time must be reset after a power failure or after the mains plug
has been unplugged.
Activate timer function
If the preparation should start automatically at the programmed switch-on time,
briefly press the button and
The LED of the start / stop button illuminates with reduced luminance.
The preparation begins automatically at the programmed switch-on time. The LED
of the start / stop button illuminates with full luminance.
Note: Once the automatic switch-on time is activated, no other settings can be made.
In order to make changes, you need to briefly press the
switch-on is deactivated again.
You can cancel the preparation at any time by pressing the Start / Stop button.
WMF Aroma Perfection
If you would like to prepare a strong aromatic coffee, you can activate the aroma
function WMF Aroma Perfection. It is particularly recommended for preparing small amounts. To do
so, prepare the Aroma
button just before you begin the brew process with the start / stop button
or activate the automatic switch-on.
The symbol appears in the display until the preparation has ended.
Note: If you wait longer than about 5 seconds to start the brewing process or activate the automatic
switch-on, the Aroma function deactivates again.
Please note that the preparation time takes a slightly longer.
WMF Pre-Brewing System
(only version with vacuum jug)
In order to achieve a particularly intense aroma, you can activate the pre-brewing
function WMF Pre-Brewing System
first for the pre-brewing. The brewing first continues only after a brief pause, during
which the coffee powder can swell. Press the
brewing process with the start / stop button or activate the automatic switch-on.
The symbol appears in the display until the preparation has ended.
Note: If you wait longer than about 5 seconds to start the brewing process or activate the automatic
switch-on, the Pre-brew function deactivates again.
Please note that the preparation time takes a slightly longer.
Automatic shut-off
(only version with vacuum jug)
After being switched on, the automatic shut-off ensures that the device does not
overheat. The device switches off only once all of the water has passed through the
filter.
It is possible to shut off the coffee maker early by pressing the start / stop button .
This could be necessary if you accidentally start the coffee machine without water.
Before filling a hot appliance, it is absolutely necessary to wait a few minutes and
allow the coffee machine to cool down.
will appear in the display.
button. The automatic
. Only a small amount of water is needed at
button briefly before you begin the
13