Preparation Of Espresso; Individual Programming; Preparation Of Hot Water - Krups Nespresso System Programatic Mode D'emploi

Preparation of Espresso

(11 – 14)
Fill the water container (1) (2) (3). To pre-
warm the capsule holder, put it in position
on the machine, but without the capsule (4).
Turn the rotary valve to the
Switch on the appliance.
The red control lamp will blink and all the
green lamps will glow steadily (7).
As soon as the red lamp also glows steadily,
the machine will be ready for use (8).
So as to prevent coffee particles becoming
lodged in the appliance, swill through the
system daily with the empty capsule holder
in position before making the first
espresso of the day and also after making
the last one (9).
Remove the capsule holder. Always insert
the capsule upside down in the capsule
holder (11). Each capsule contains sufficient
ground, fresh coffee for one cup of espresso.
Reinsert the capsule holder in the retaining
ring and secure it firmly by turning the
handle so that it is at right angles to the
front of the machine or points slightsy to the
right (12).
Place the pre-warmed cups (see the section
on "pre-warming of espresso cups") under-
neath the capsule holder.
Your appliance is already pre-programmed
for the preparation of espresso (small cup, 50
ml) or cappuccino (large cup, 120 ml). You
now prepare whichever you want by pres-
sing either the key
After having made the espresso, remove the
capsule holder and dispose of the used
capsule (14). After the preparation of
espresso, the red lamp will glow in order to
reach the operating temperature again.
16
position (6).
or the key (13).
However, the preparation of further
espresso is possible at any time.
So that you can produce your next espresso
under the optimum temperature conditions,
return the empty capsule holder to the
retaining ring without delay.

Individual Programming

(15 – 17)
Should you wish to alter the pre-program-
med quantities of liquid for large or small
cups, please proceed as follows:
Switch on the appliance.
Insert a capsule into the capsule holder
and position the capsule holder in the
appliance.
Put a cup under the capsule holder.
As soon as the red control lamp glows
steadily, press the memory key
-key green control lamp will blink and
the green control lamps for large and
small cups will glow steadily (15).
Press and hold down the
desired quantity of espresso has been
reached (16).
Now press the
espresso and to store this quantitiy in the
memory (17). To programme the quantity
for a large cup, just repeat this process
using the key.

Preparation of Hot Water

(18)
With this appliance, you can prepare hot
water for tea, instant coffee, bouillon and
the like.
Fill the water container and turn the
rotary valve to the
Switch on the appliance.
. The
key until the
-key to stop the flow of
position.