Accessories; Setting-Up The Appliance; Preparation Of Espresso - Krups Nespresso 897 Mode D'emploi

Never immerse the appliance in water.
•
• Keep out of reach of children and do not
allow the cord to hang down.
Follow the descaling instructions.
•
Do not use the appliance if it is damaged or
•
if the cord is in poor condition.
If the cord or any other specific part
•
becomes defective, these must be replaced
by a Krups approved service centre. You
should never, under any circumstances, open
the appliance yourself.
Check that the capsule holder is firmly in
•
place before making coffee.

Accessories

For best results, the appliance is delivered with
a set of accessories.
• 4 Nespresso cups
4 varieties of Nespresso coffee (4x10
•
capsules)
1 special hexagonal key (for dismantling the
•
capsule holder)
• 1 cleaning needle
For further information on the different
varieties of coffee available, or to order
capsules, you should contact your Nespresso
Club. Details on your appliance or in the «
Welcome Pack ».

Setting-up the appliance

Lift the water tank lid and remove the water
•
tank (1).
Fill the water tank with fresh water (2).
•
Maximum capacity is
1.8 l = about 25 espresso cups.
• Replace the water tank and press down
firmly into position, so that the lower valve
opens (3).
• Close the lid again.
For a good cup of espresso, it is
recommended tha you observe the following
points:
Empty the water tank after use.
•
Change the water every day.
•
• Do not use mineral water or distilled water.
Clean the water tank at least once a week.
•
Before using your espresso
maker for the first time
Plug in the appliance.
•
Introduce the empty capsule holder into the
•
fixing ring : to do this, position the handle at
about 90° to the left, then thighten up by
pulling the handle firmly to the right (4).
§ Fill the water tank.
Place a container, large enough, under the
•
capsule holder and another under the steam
nozzle (5).
Turn the steam/hot water button to the
•
position (6).
• Press the ON/OFF key
indicator light will flash and all the green
indicator lights will come on (7).
Once the red operating indicator light stops
flashing the appliance is ready to be used (8).
• By pressing the key
through the system (9).
• Repeat this operation five times.
• Press the and turn the steam/hot water
button to the position (10). Allow about
half a litre of water to run through and then
turn the steam/hot water button to the
position.

Preparation of Espresso

Fill the water tank (1) (2) (3).
•
Preheat the capsule holder, put it in position
•
on the machine, but without the capsule (4).
Turn the steam/hot water button to the
•
position (6).
Press the ON/OFF key
•
light will flash and all the green indicator
lights will come on (7). Once the red
operating light stops flashing the machine is
ready for use (8).
, the red operating
, the water will run
, the red operating
15