Error Displays/Messages - Sony DSX-MS60 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The display items do not scroll.
• A large number of characters may not scroll.
• "A.SCRL" is set to "OFF."
t Set "A.SCRL-ON" (page 20).
t Press and hold (DSPL) (SCRL).
A beep sounds.
During playback, the USB device has been
disconnected.
t Before disconnecting a USB device, make sure to
stop playback first for data protection.
The sound is intermittent.
The sound may be intermittent at a high-bit-rate of
more than 320 kbps.

Error displays/Messages

CHECKING
The unit is confirming the connection of a USB device.
t Wait until confirming the connection is finished.
DEVICE INSIDE
If you turn the ignition switch to the OFF position
without removing the USB device or iPod, "DEVICE
INSIDE" will appear in the display.
ERROR
USB device was not automatically recognized.
t Reconnect it again.
FAILURE (Illuminates until any button is pressed.)
The connection of speakers/amplifiers is incorrect.
t See the installation/connections manual of this
model to check the connection.
FAILURE (Illuminates for about 1 second.)
When the SAT tuner is connected, storing an SAT
radio channel into a preset failed.
t Be sure to receive the channel that you want to
store, then try it again.
HUB NO SUPRT (HUB Not Support)
USB hub is not supported on this unit.
L. SEEK +/–
The local seek mode is on during automatic tuning.
NO DEV (No Device)
USB is selected as source without a USB device
connected. A USB device or a USB cable has been
disconnected during playback.
t Be sure to connect a USB device and USB cable.
NO MUSIC
The USB device does not contain a music file.
t Connect a USB device with a music file in it.
NO NAME
A album/artist/track name is not written in the track.
OFFSET
There may be an internal malfunction.
t Check the connection. If the error indication
remains on in the display, consult your nearest
Sony dealer.
26
OVERLOAD
USB device is overloaded.
t Disconnect the USB device, then change the source
by pressing (SOURCE/OFF).
t Indicates that the USB device is out of order, or an
unsupported device is connected.
READ
The unit is reading all track and album information on
the USB device.
t Wait until reading is complete and playback starts
automatically.
RESET
USB device cannot be operated due to a problem.
t Press the RESET button (page 6).
USB NO SUPRT (USB Not Support)
The connected USB device is not supported.
t For details on the compatibility of your USB
device, visit the support site.
"
" or "
During reverse or fast-forward, you have reached the
beginning or the end of the USB device and you cannot
go any further.
"
"
The character cannot be displayed with the unit.
If these solutions do not help improve the situation,
consult your nearest Sony dealer.
"

Publicité

Table des Matières
loading

Table des Matières