emerio WC-126433 Mode D'emploi page 17

TROUBLESHOOTING
Some issues can be easily resolved. Before using after-sales service or a repairman, please see the following
table:
Problem
The appliance doesn't
work.
The appliance is not
cold enough.
The compressor works
and goes out often.
The light doesn't work. The socket is not plugged in.
Vibration.
The appliance seems
to be making too much
noise.
The door doesn't close
properly.
If your appliance doesn't seem to be working normally, unplug the device for a few minutes, then plug it in again
to reset the appliance.
If the problem persists or for any other problems occurring at your device: contact the After-Sale Service.
Any service or repair on the cooling process must be carried out by a licensed professional who will have to carry
out an inspection of the refrigeration circuit.
Similarly, any service or repairs on the electrical circuit must be carried out by a qualified electrician.
Note: Any repair by an unlicensed technician will result in cancellation of the warranty.
TECHNICAL SPECIFICATIONS
Rated voltage:
Rated current:
Rated frequency:
Climate class:
Refrigerant:
Protection against electrical shock:
Insulation blowing gas:
POSSIBLE CAUSES
The appliance is not plugged in or it is switched off.
The circuit breaker is triggered, or the fuse is damaged.
Check to see if the power outlet is powered by connecting another electrical
appliance.
Check the temperature setting.
A high ambient temperature may require a higher setting.
The door is opened too often.
The door is not completely closed.
The door seal is not properly positioned.
The room temperature is warmer than normal.
A large quantity of bottles has been added to the appliance.
The door is opened too often.
The door is not completely closed.
Temperature control is not properly defined.
The door seal is not properly positioned.
The circuit breaker has gone off or a fuse is damaged.
The appliance may not be level.
Squeaking or slamming may come from the circulation of the refrigerant gas, which
is normal.
At the end of the cycle, the compressor emits a noise caused by the passage of the
refrigerant into your appliance.
The contraction and expansion of the gas inside the walls can emit hissing and
crackling.
The appliance is not level. Check the setting of the feet.
The door was reversed and not properly reinstalled.
The seal is defective (the magnet or rubber is altered).
The shelves block the door closure.
220-240V~
2.0A
50Hz
N/ST
R600a (28g)
I
CYCLOPENTANE
- 16 -