emerio WC-126433 Mode D'emploi page 15

L1: View temperature by selected area
Temperature display:
A: Top zone: 5-12 ˚C
B: Bottom zone: 12-18 ˚C
Note: Symbol "%" in the lower right corner means humidity. It is not applicable to this product/model you
purchased.
K4: Increase temperature
Press the key once, the LED display will flash indicating the current temperature. Press again to set the
temperature. One touch will increase the temperature by one degree. The blink stops after 5 seconds without
action on your part, and the newly set temperature is recorded. The LED display then shows the actual
temperature inside.
K5: Decrease temperature
Press the key once, the LED display will flash indicating the current temperature. Press again to set the
temperature. One touch will reduce the temperature by one degree. The blink stops after 5 seconds without
action on your part, and the newly set temperature is recorded. The LED display then shows the actual
temperature inside.
K6: Settings
Fahrenheit/Celsius
Switch the temperature display between Fahrenheit/Celsius by pressing the key.
There are two internal fans for airflow however fluctuations of up to 3 degrees is expected. The average
temperature throughout the appliance will be a maximum of 1.5˚C of the requested temperature (once
sufficient time for cooling has passed). Once a temperature difference of 3˚C above the set temperature is
detected, the cooling cycle will start to bring the temperature down to below the set temperature. Once the
cooler temperature is reached, the cooling stops and the temperature inside the appliance is allowed to slowly
increase. This cycle is continuous and results in a very small range of constant fluctuation.
The temperature sensor is placed halfway down the compartment and reads the temperature instantaneously.
Small amounts of deviation in temperature are expected (less than 6˚C).
Please do not open the door too often as this will disrupt the operation of the temperature sensors. The
appliance automatically adjusts moisture and condensation levels within the appliance as required.
Attention
When the temperature sensor is failing due to power outage or bug, an error code appears.
E1: internal temperature problem
E2: ambient temperature problem
CE: communication problem
5. Wine service temperatures
The table below shows the recommended serving temperatures for different wine.
Wine
Champagne, sparkling
White: Sémillon, Sauvignon Blanc
Vintage Champagne
Dry white: Chardonnay
Dry white: Gewürztraminer, Riesling, Pinot gris
Recommended temperature
6 °C
8 °C
10 °C
10 °C
10 °C
- 14 -