emerio WC-126433 Mode D'emploi page 11

8. Place the door on the lower hinge. Make sure the glass door is
upright and closes easily.
9. Place the top hinge on the opposite side.
10. Place the door on the appliance, then loosely screw the hinge
without tightening completely.
11 Once the door is installed, adjust the hinge by tightening the
screws until the door is in the correct place.
12. Replace the top hinge cover.
Note: The door seal may come out of its place when changing the door. If you notice gaps between the seal and
the appliance frame when the door is closed, pull carefully on the seal to close these openings. The correct
positioning of the seal is important to ensure the appliance is waterproof.
BEFORE USE
Prior to first use
Caution:
After transport, the appliance should be left standing upright for 24 hours before connecting to the power supply.
Nonobservance could lead to malfunction of the cooling system and causes an appliance break-down.
Clean the appliance interior including all accessory parts. Consider the instructions which we provide in the
chapter "Cleaning and Maintenance".
Leave the appliance open to eliminate residual odors.
Recommendations:

Place the appliance in a cool place away from sunlight and heat sources.

Certain parameters such as room temperature, door opening time or the number of bottles stored inside
could affect the internal temperature of your appliance. We recommend that you check the internal
temperature regularly and adjust it if necessary.

Do not cover the vents.
Operating noise:
To reach the desired temperature, this appliance, like all wine fridges with compressor cooling systems, can
produce certain noises, which are normal operating noises.
- 10 -