emerio WC-126433 Mode D'emploi page 10

Electrical connection
Warning:

The installation to the mains supply must conform to the local standards and regulations.

Improper connection may cause to an electric shock!

Do not modify the appliance plug. If the plug does not fit properly to the outlet, let install a proper outlet
by an authorized specialist.

The accessibility of the power plug must be ensured to disconnect the appliance from the power supply in
case of emergency.

Make sure that the voltage supply matches the specifications on the rating label before connecting.

Connect the mains cable to a properly installed and earthed wall outlet.

If the plug after installation is not accessible, a corresponding disconnect device must be available to meet
the relevant safety regulations.
Changing the orientation of the door
The door can be right or left opening. Change the door by following the instructions below. Making this change
requires 2 people.
Instructions for changing the "right-hung" door and reassembling it so it is "left-hung":
(The pictures below are for the guideline to reverse the door. The appearance of the appliance may be different
from the product you purchased.)
1. Unplug the power cord from the socket.
2. Remove the top hinge cover.
3. Unscrew the top hinge and remove it, then remove the door by
gently lifting it.
4. Unwind the front right foot completely until it comes off. Remove
it.
5. Unscrew the lower hinge and remove it.
6. Place the lower hinge on the opposite side after removing the
front foot and attach the hinge with the screws you have just
removed from the right side.
7. Replace the foot on the left side of the appliance with the
adjustable foot removed from the right side. Screw the smaller foot
onto the right side.
- 9 -