The Input Selector Menu {Sel; The Delay Menu {Dlay - Miranda UAP-711i Notice D'installation Et D'utilisation

Guide to installation & Operation

3.4.2 The input selector menu {SEL}

This is a stereo input selector for the module. These parameters can be accessed by remote control.
Procedure
• Press [+] or [-] displays the {SEL} menu,
• Press [SEL] displays I-1&2, use [+] or [-] to scroll through the available channels I-1&2, I-1, I-2 (UAP-
712i only).
• Press [SEL] validates the channel and displays the current value, use [+] or [-] to scroll through the
available values ANLG, DIGT or Abus.
• Press [SEL] to store the new value and to return to the previous menu
• Or press [ESC] to return to the previous menu without updating the parameter.
• To turn off the display, press [ESC].

3.4.3 The delay menu {DLAY}

This menu is used to configure the delay applied to an input signal. The value of the delay is the sum of
a fixed part accessed via the {FIXD} menu and a remote controlled variable part (tracking delay)
accessed via the {TRAK} menu. The total maximum value of the delay is 10 sec. for a 48 kHz output
sample rate. When TRAK is on, the maximum value displayed by {FIXD} menu is reduced of the
amount of delay reserved for tracking.
The {LINK} menu, UAP-712i only, enables to copy the tracking delay from channel 1 to channel 2. A
precise description of operating mode is given at section 2.5.4 "Fixed or remote controlled delay". These
parameters can be accessed by remote control.
Procedure
• Press [+] or [-] displays {DLAY},
• Press [SEL] displays I-1&2, use [+] or [-] to scroll through the available channels, I-1&2, I-1, I-2 (UAP-
712i only)
• Press [SEL] validates the channel and displays FIXD, use [+] or [-] to scroll through the available
parameters FIXD, TRAK, LINK.
• Press [SEL] validates the parameter and displays the current value, use [+] or [-] to scroll through the
available values.
• Press [SEL] to store the new parameter, and to return to the previous menu
• Or press [ESC] to return to the previous menu without updating the parameter.
• To turn off the display, press [ESC].
20
x UAP-711i/712i