Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3 Operation
3.1 UAP-711i or UAP-712i user interface
The Figure below illustrates the UAP-711i or UAP-712i user interface situated at the front end of the
card. For information on these controls, refer to the rest of this section.
BICOLOR
GREEN
YELLOW
RED
LOCK
L
INPUT 1
UAP-711i
UAP-712i
Figure 11: UAP-711i or UAP-712i user interface
Status leds
INPUT 1
LOCK (bi-color)
L (1 green + 1 red)
R (1 green + 1 red) These two Leds correspond to channel 1 right.
TEST (yellow)
INPUT 2
LOCK (bi-color)
L (1 green + 1 red)
R (1 green + 1 red)
TEST (yellow)
REF
(Bi-color)
Front panel pushbuttons
[SEL]
Activates the displayed parameter
[-]
Decreases value of selected parameter
[+]
Increases value of selected parameter
[ESC]
Returns to previous parameter
Main menu parameters
Input status
Input Selector
Delay
Channel swapping
Input level adjustment
Phase Inversion
Mixing
Test (tone generator)
Output level adjustment
R
TEST LOCK
L
R
TEST REF
INPUT 2
ESC.
UNIVERSAL AUDIO PROCESSOR
Green:
AES signal detected.
Orange:
non-audio signal detected.
Red:
indicates parity error, coding error or a no lock condition on
AES input.
The two Leds are assigned to channel 1 left after the ANLG, DIGT or
Abus input selector.
Green:
lights when a signal is present (threshold –60 dBFS).
Red:
indicates overload or an absence of signal for 15 seconds.
EBU tone or mute selected.
These Leds correspond to input 2.
Green, orange or red: indicates the lock/no-lock condition of the AES
outputs (refer to synchronization paragraph 2.5.3)
Guide to installation & Operation
FRONT VIEW
TOP VIEW
-
+
Mute (AES silence)
Monitoring functions
Alarm deactivation
ABUS (interface with video synchronizer)
AES channel status source
AES mode (Pro. or Consumer)
AES Origin and destination message
AES output format
Factory configurations
UAP-712i
SELECT
13
UAP-711i/712i x
Publicité
Table des Matières
