The Mixing Menu {Mix; The Tone Generator Menu {Test - Miranda UAP-711i Notice D'installation Et D'utilisation

Guide to installation & Operation

3.4.7 The mixing menu {MIX}

This menu enables to substitute the contents of one or more audio channels by a mono reduction of two
or four modulations (UAP-712i only). Three mono combinations are generated from the four input
signals: 2MIX-1 (1L+1R), 2MIX-2 (2L+2R) and 4MIX (1L+1R+2L+2R) - refer to the block diagram. The
mixing of two channels is made at –6 dB to avoid overload. These parameters can be accessed by
remote control.
Procedure
• Press [+] or [-] displays {MIX},
• Press [SEL] displays O-1&2, use [+] or [-] to scroll through the available outputs O-1&2, O-1, O-2
(UAP-712i only).
• Press [SEL] validates the output and displays L&R, use [+] or [-] to scroll through the available values
L&R, L, R.
• Press [SEL] validates the channel and displays the current value, use [+] or [-] to scroll through the
available values OFF, 2MIX or 4MIX.
• Press [SEL] to store the new parameter, and to return to the previous menu
• Or press [ESC] to return to the previous menu without updating the parameter.
• To turn off the display, press [ESC].

3.4.8 The tone generator menu {TEST}

This menu enables or disables the tone generator. The internal tone generator provides a 1 kHz
(-18 dBFS) continuous sine wave. The EBU mode provides channel identification: left channel is cut off
for 250 ms every three seconds. These parameters can be accessed by remote control.
Procedure
• Press [+] or [-] displays {TEST},
• Press [SEL] displays O-1&2, use [+] or [-] to scroll through the available outputs O-1&2, O-1, O-2
(UAP-712i only).
• Press [SEL] validates the output and displays the current value, use [+] or [-] to scroll through the
available values OFF or EBU.
• Press [SEL] to store the new parameter, and to return to the previous menu
• Or press [ESC] to return to the previous menu without updating the parameter.
• To turn off the display, press [ESC].
22
x UAP-711i/712i