Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Guide to installation & Operation
2.3 Rear panel label
2.3.1 Quartet frame
Two connector labels have been shipped with your UAP-711i or UAP-712i. One label is to be connected
on the Quartet tray rear panel in order to identify the UAP-711i or UAP-712i external connectors. UAP-
711i corresponds to only channel 1; UAP-712i corresponds to channel 1 and 2. The rear panel is
always equipped with UAP-712i rear panel.
1.
To install the label, follow these steps
2.
On the tray's rear panel, locate the UAP-711i or UAP-712i connectors
3.
Carefully, apply the label to the connectors
Figure 2: Example of label installation
2.3.2 Symphonie Frame
To install the Symphonie label, follow these steps while
referring to Figure below
1.
On Symphonie 's rear panel, locate the
appropriate connectors.
2.
Carefully apply the label to the connectors
making sure the label's text is read from top to
bottom.
8
x UAP-711i/712i
Figure 3: Symphonie rear panel label installation
Publicité
Table des Matières
