Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Procedure
Install Appliance
9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
1
Mark the center of the recess exactly. Fit the long
mounting rail to the front, the short mounting rail to
the rear of the recess. Make sure the lugs of the
mounting rails lie on the worktop. The center
marking on the mounting rail must be precisely
flush with the center marking of the recess.
Note: when fitting the appliance in a stone
countertop glue on the mounting rails with a
temperature-resistant two-component adhesive
(metal on stone).
2
Lower the appliance into the cut-out. The snap-in
pins on the appliance must lie exactly on the catch
springs. Firmly press the appliance into the cut-out.
The pins on the appliance must snap into the catch
springs.
Ventilation molding
If the downdraft ventilation is operated next to a gas
appliance, an air conduction rail LS 041 000 must be
attached to the gas appliance when cooking. The air
conduction rail improves the intake behavior of gas
appliances. The air conduction rail prevents the putting
out of small flames due to drafts.
9
Publicité
Table des Matières
