Installation Procedure; Mounting Control Knobs - Gaggenau VL 414 712 Notice De Montage

en-us

Installation Procedure

Flush installation: The appliance can be installed in the
following temperature- and water-resistant countertops:
Stone countertops
▯
Plastic countertops (such as Corian®)
▯
Solid wood countertops: Only in consultation with the
▯
manufacturer of the countertop (seal cut-out edges)
Installation in other countertops only in consultation
▯
with the manufacturer of the countertop.
Installation in countertops made of particleboard is not
possible.
Note: Any cut-out work on the countertop must be
performed in a workshop according to the installation
diagram. The cut-out must be made cleanly and precisely
since the cut-out edge is visible on the surface. Clean
and degrease the cut-out edges with a suitable cleaning
agent (bear in mind silicone manufacturer's processing
instructions).
Combining several Vario devices: The connecting strip
VA 420 000/010 is required for the combination of
several Vario appliances. This is available separately as a
special accessory. Consider additional space
requirement for the connecting strip between the
appliances when making the cut-out (see installation
instructions VA 420 000/010).
Appliances can also be installed in individual cut-outs,
bearing in mind a minimum distance between the devices
of 2" (51 mm).
10
Installation Procedure
M ounting Control Knobs
I n s t a l l a t i o n P r o c e d u r e
Note: Follow the installation instructions provided for the
control knobs.
1.
Depending on the distance between the control
knobs, it may be necessary to break off the retaining
plate at the perforation. Hold the retaining plate in
place against the back of the control panel or the
bottom of the countertop, or secure it with the
enclosed screws.
2.
When installing a single control knob or when the
retaining plate has been broken at the perforation, use
2 screws to hold each individual retaining plate in
place to prevent it from rotating (C).
For stone countertops, use temperature-resistant two-
component adhesive (for metal to stone) to adhere the
retaining plate.
3.
Remove the protective film on the back of the
illuminated ring (A).
4.
Insert the control knob into the drilled hole (B) and
screw the nut on the back with the enclosed
installation aid (D).
5.
Connect all of the control knobs with the enclosed
shorter cables. The plugs must snap into the sockets
(E).
Note: The two cable connectors on the control knob
are identical.
6.
Connect the longer cable to the control cable for
connection to the appliance. The plug must snap into
the socket (F).
Note: The appliance can be connected to any control
knob.