HAIDER BIOSWING 230 iQ V works Mode D'emploi page 12

Adjustment of Seat Depth
4
The adjustment of the seat depth helps you to adjust the seat surface to the
length of your upper leg. Make sure that the front edge of the seat is at a
distance of six inches from the hollow part of the knee.
Individually Adjusted Seat Surface
While sitting, pull the operating element
shift the seat forward and backward by pushing the seat cushion. Then re-
lease the operating element.
Version without Operating Handle: With the help of the integrated quick-
release lever at the bottom side of the seat cushion (in the front at the right
side of the seat support), the seat depth can be changed by about 2,5 cm.
Lift the quick-release lever, change the position of the seat cushion, and
press the quick-release lever tightly on again. (Note: If the seat cushion can-
not be moved, turn the loosened quick-release lever counterclockwise . If the
seat cushion is not fixed tightly after its change of position, turn the loosened
quick-release lever clockwise.)
4
upward and simultaneously
4
english | 22
Arm, Height adjustable (1F)
To relieve the strain on shoulders and neck, the arms can be adjusted in
height. Adapt the height so that you do not feel any tension in the shoul-
der area.
Adjustment of Arm in Height
Pull the operating element upward. At the same time, adjust the arms
5
at the desired height and then release the cord-pull switch.
(Arms allow adjustment to the width by using the elongated guide with position holes at the beam
holding the arms up. Loosen the screws at the bottom of the seat cushion. Adjust the width by
pulling the arms outward or inward and then tighten the screws firmly.)
5
english | 23
5