afx light PARLED100-Z Manuel D'utilisation page 5

The beam angle can be adjusted manually, which is 9°/15°/20°/25°/30°.
MENU
To select any functions, press the MENU button until the required function is
showing on the display. Select the function by pressing the ENTER button and
the display will blink. Use the DOWN and UP button to change the mode. Once
the required mode has been selected, press the ENTER button to setup to go
back to the functions without any changes press the MENU button again. Hold
and press the MENU button for one second or wait for one minute to exit the
menu mode.
The main functions are shown below:
DMX 512 ADDRESS
To select Addr, press the ENTER button to show the DMX ADDRESS on the display. Use the DOWN/UP button to adjust the
address from 001 to 512. Once the address has been selected, press the ENTER button to setup, to go back to the
functions without any changes press the MENU button again. Hold and press the MENU button for one second or wait for
8 seconds to exit the menu mode.
CHANNEL MODE
To select Chnd, press the ENTER button to show the DMX CHANNEL MODE on the display.
Use the DOWN/UP button to select 1 or 2 channel mode. Once the mode has been selected, press the ENTER button to
setup, to go back to the functions without any changes press the MENU button again. Hold and press the MENU button for
one second or wait for 8 seconds to exit the menu mode.
Dimmer Mode
Select , press ENTER button. Use the DOWN and UP button to select
(Dimmer Mode 4). Once selected, press the ENTER button to setup or exit menu mode without any change after 8 seconds.
Back to the functions without any change press the MENU button again.
©Copyright Lotronic 2018 PARLED100-Z
(Dimmer Mode 1)...
5