Numark OMNI CONTROL Guide D'utilisation Simplifié page 7

ROUTING AUDIO OUTPUTS IN TRAKTOR
If you are using the OMNI CONTROL with Native Instruments' Traktor or Traktor LE software applications, please see the
example and instructions below for information on routing your audio outputs to take full advantage of cueing and
monitoring.
1. In Traktor, click on Preferences.
2. Choose Audio Setup and click on the
Soundcard tab.
3. Next, under the Audio Device pull-down
menu, select OMNI CONTROL ASIO
Driver.
4. Then click on the Output Routing tab.
5. Lastly, you can choose which outputs you
would like to use for your Master and
Monitor channels from the pull-down menu
on the bottom.
output on the OMNI CONTROL is tied to
the Output 2 stereo
recommend using the Output 1 pair as your
Master channel and the Output 2 pair as
your Monitor channel.
Additional Information: You may also wish to send each virtual "deck" independently to each output pair on the
OMNI CONTROL for use with an external mixer.
Output Routing tab. You will then be able to decide which deck is being sent to which output pair.
ROUTING AUDIO OUTPUTS IN MIXMEISTER
If you are using the OMNI CONTROL with the Mixmeister DJ software application, please see the example and
instructions below for information on routing your audio outputs to take full advantage of cueing and monitoring.
1. In Mixmeister, go to the Tools menu and select Audio Output Configuration.
2. You will see a window similar to the one below. (MixMeister Fusion Live shown)
3. Select Dual Output option.
4. Under the Main output (speakers) pull-down menu, select Numark OMNI CONTROL Audio.
5. Under the Preview output (headphones) pull-down menu, select Numark OMNI CONTROL Audio.
6. Click OK.
Since the Headphone
RCA pair, we
To do so, please select External as the Mixer Mode in the
7