Numark OMNI CONTROL Guide D'utilisation Simplifié page 3

:: Omni Control Quickstart Guide ::
This Quickstart Guide explains how to quickly setup and begin using the Numark OMNI
CONTROL DJ system. Please take a few minutes to go through this Quickstart and get familiar
with the setup procedure and basic controls.
We have designed OMNI CONTROL as a complete system for software-based DJs.
CONTROL is a MIDI-compliant device and can be used with any software which supports the
MIDI protocol. We have included two software packages – Native Instruments' Traktor LE and
MixMeister Fusion Live – enabling you to DJ right out of the box. Plus, you can play your mixes
through this software or from OMNI CONTROL itself. Two sets of RCA connections on the rear
panel allow you to send your master and cue mixes to remote speaker or amp systems.
We also highly recommend reading the software reference manuals, included on the installation
disc, in order to take full advantage of OMNI CONTROL. Happy DJing!
A NOTE ABOUT MIDI CONTROL :::::
Omni Control was designed as a MIDI-compliant device, allowing you to control any
computer application which supports the MIDI protocol. This means that you can not
only use Omni Control with the included software, but can also use the controller with
a variety of other music and video applications as well. In order to use Omni Control
with your favorite software, you will have to enable Omni Control as a MIDI input
device in your software's preferences. Please note that depending on your software,
the Omni Control may not necessarily show up as "Omni Control" in the MIDI
preferences.
Please Note: If you are using Omni Control with a USB hub, we recommend that you either use a
powered hub, or the optional 6V 1A power adapter. This will ensure proper operation.
BOX CONTENTS
OMNI CONTROL
QUICKSTART MANUAL
SAFETY & WARRANTY INFORMATION
USB CABLE
MIXMEISTER FUSION LIVE COUPON
SOFTWARE/DRIVER CD
3
OMNI