Other Settings; Turning The Display Off; Dimming The Display; Changing The Clock's Display Mode - Pioneer ELITE X-Z9 Mode D'emploi

Other settings

Chapter 10
Other settings

Turning the display off

• Press DISP OFF.
When you turn the display off, the DISPLAY OFF
indicator lights. If you press DISP OFF once more, the
display is once again shown.
• Even when set to not display, the display is temporarily
shown when you carry out a control function.

Dimming the display

You can choose one of three brightness settings for the
front panel display.
When set to AUTO, the display is shown brightly only
when you carry out a control function.
1 Press SETUP.
2 Use the buttons to choose 'Dimmer' then press
ENTER .
3 Use the buttons to adjust the brightness of the
display then press ENTER .

Changing the clock's display mode

You can choose to display the clock in 12-hour mode or
24-hour mode.
1 Switch the system into standby.
2 Press SETUP.
3 Use the buttons to choose 'Hour Display' then
press ENTER .
4 Use the buttons to select '12H' or '24H' then
press ENTER .

Disabling color reverse of the display

If no operations are carried out for three minutes, the
colors of the text on this unit's display reverse. You have
the option to disable this feature.
1 Switch the system into standby.
2 Press SETUP.
3 Use the buttons to choose 'Reverse Display'
then press ENTER .
4 Use the buttons to select 'Mode Off' then
press ENTER .
• To turn Display Reverse back on, choose Mode On.
Changing the frequency step of the
AM tuner
If you find that you can't tune into stations successfully,
the frequency step may not be suitable for your country/
region. In this case, try switching between 9 kHz and 10
kHz frequency steps and select the one that produces the
best results.
1 Switch the system into standby.
2 Press SETUP.
3 Use the buttons to select 'AM 9K/10K', then
press ENTER .
4 Use the buttons to select 'AM 9K' or 'AM 10K'
then press ENTER to confirm.

Volume mode setting

You can set the sensitivity of the volume control to either
a 50-step system or an 80-step system.
1 Switch the system into standby.
2 Press SETUP.
3 Use the buttons to choose 'Volume Step' then
press ENTER .
4 Use the buttons to select '80 Step' or '50 Step'
then press ENTER .
• When the mode is changed, the volume returns to 0.

Resetting the system

Use this procedure to reset all system settings to the
factory default.
1 Switch the system on.
2 Press and hold FUNCTION on the front panel, and
then press and hold STANDBY/ON for three
seconds.
Power is set to standby mode.
The next time you switch on, all the system settings
should be reset.
10
35
En