Connecting The Device To The Gas Canister - Enders COMMERCIAL Manuel D'installation Et D'utilisation

GB
The ventilation holes on the container sleeve of the canister must not be covered. It is
possible that gas could leak out and collect in the holder which creates a risk of explosion.
When the device is turned on, the gas canister should always be placed in the designated
container sleeve.
In order to prevent injury from sharp edges we recommend wearing safety gloves during as-
sembly.
Only use the gas types and canisters recommended by the manufacturer!
Repairs and maintenance of gas-related parts are only to be carried out by authorised
specialists.
In case of malfunction, the regulator valve should be closed.
The gas hose should be inspected for damage at least once a month and each time the canister
is changed.
specialist. After 10 years you have to replace the gas hose and pressure regulator by an
authorised specialist!
In the event of a gas leakage, the device should not be used. If it is in use, the gas supply must
be blocked. Before it is used again, the device must be thoroughly checked and any damaged
parts replaced. Any loose connections must be tightened.
3.

CONNECTING THE DEVICE TO THE GAS CANISTER

pressure 30 mbar
approved 1.4 m hose
A Union nut
B Regulator valve
C Canister valve
D
E Gas supply
Y Gripper clamp
Z
B
Illustration 2.
20
E
A
Y
D
Z
C