Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Setting the units of measurement:
You can alternate between two units of measurement for the height
above sea level and the atmospheric pressure by pressing the UNIT
button in the weather station's battery compartment. Simply switch
to the relevant display by pressing the PRESSURE/ALTITUDE button
and then press and hold the UNIT button for approx. 3 seconds. The
respective unit of measurement starts to fl ash. You can now use the
arrow buttons in the weather station's battery compartment to alter-
nate between hPa/mBar and inHg for the atmospheric pressure and
between Meter and Feet for the height above sea level. Confi rm your
selection by pressing the UNIT button again.
The weather station also has a graphical display to indicate the atmos-
pheric pressure over the past 24 hours.
WEATHER FORECAST
The weather forecast is an approximate indication that is calculated
for the next 12-24 hours over a radius of approximately 30 to 50 km.
It is based on the fl uctuations of atmospheric pressure and it predicts
actual weather conditions with an accuracy of 70%. As it is not pos-
sible to predict the weather with 100% accuracy, we do not accept
any liability for damage which may occur as a result of an incorrect
weather forecast.
The weather forecast is displayed using the following symbols:
Indicator
displays on
the unit
Forecast
Sunny
Slightly
Cloudy
Cloudy
47
GB/IE
Rainy
Snowy
Publicité
Table des Matières
