Moon Phase Display; Low Battery Display - Bresser TemeoTrend NBF Mode D'emploi

MOON PHASE DISPLAY

The display for the current moon phase is located to the left below
the atmospheric pressure display. The moon phase depends on the
current date and is displayed with the following symbols:
You can display the moon phases for the previous and next 39 days
by using the arrow buttons in the weather station's battery compart-
ment. The respective day is indicated in the small display window lo-
cated to the right of the moon phase display.
New Waning
Moon Crescent

LOW BATTERY DISPLAY

Weak batteries in the base station and external sensor are indicated
by the low battery display [
weather station with ordinary batteries as opposed to rechargeable
batteries.
TROUBLESHOOTING
Please check the batteries before issuing a complaint about the wea-
ther station and replace these, if necessary, with new batteries.
The external temperature is no longer displayed on the base station:
If the external sensor no longer registers, this may be for one of the
following reasons:
• The batteries in the external sensor and/or base station are too
weak. Replace the old batteries. Never use a mixture of old and
new batteries and proceed as described under the section en-
titled „Sensor call button" to re-register the sensor.
• External sensor reception is interrupted by obstacles. As these
are often impossible to remove (e.g. thermopane glazing, walls
First Waxing
Quarter Gibbous
50
Full Waning
Moon Gibbous
]. We recommend you operate the
Last Waning
Quarter Crescent