Bresser TemeoTrend NBF Mode D'emploi page 39

BEGINNING OF OPERATION
We recommend that you read these operating instructions thor-
oughly before starting to use the weather station. Conduct the
commissioning procedure on a table where the base station and the
external sensor can be positioned or set up next to each other. In
order to be able to operate the weather station, please remove the
protective fi lm from the base station display.
CAREFUL!
Keep this protective fi lm away from babies and
young children as it is a suffocation hazard!
Remove the battery compartment cover located at the rear of the
base station. Also remove the battery compartment cover located at
the rear of the external sensor. Please unscrew this cover using a
small screwdriver.
Please make sure that the batteries are always inserted into the
external sensor fi rst and then into the base station, otherwise
the base station may not receive the signal from the external
sensor.
Now select your desired channel by using the slider in the external
sensor's battery compartment and then insert the 2 x 1.5V AA bat-
teries into the compartment (observe the correct polarity +/-). Then
insert 2 x 1.5 V AA batteries into the battery compartment of the base
station (observe the correct polarity +/-).
NOTE!
Please make sure that the batteries are new and of
the correct size.
39
GB/IE